Indesit K6T21(X)/EX Bedienungsanleitung PDF herunterladen (Seite 6)

• check that the flame does not turn off when you turn the tap

quickly from high to low.

d) Regulating the primary air of the burners:

The primary air of the burners requires no regulation.

Adapting to different types of gas

In order to adapt the oven to a different type of gas with

respect to the gas for which it was manufactured (indi-

cated on the label), follow these simple steps:

a) Replacing the oven burner nozzle

· open the oven door fully

· pull out the sliding oven bottom

· unscrew the burner fastening screws

· remove screw “V” and then the oven burner;

· Unscrew the oven burner nozzle using the special

socket spanner for the nozzles, or a 7 mm socket span-

ner, and replace it with a nozzle suited to the new type

of gas (see Table 1).

Take particular care handling the spark plug wires

and the thermocouple pipes.

· Replace all the parts, following the steps described

above in the reverse order.

b) Minimum regulation of the gas oven burner with thermostat:

• light the burner as described in the paragraph “the oven knob”

of the instruction booklet.

• turn the knob to Max for about 10 minutes and then turn the

knob to the Min setting;

• remove the knob;

• regulate the screw positioned outside the thermostat pin

until the flame is small but steady.

N.B.: in the case of natural gas, the adjustment screw

must be unscrewed by turning it anti-clockwise.

• check that the burner does not turn off when you turn the

knob from Max to Min and and when you open and close

the oven door quickly.

Adapting the gas grill to different types of gas

Replacing the nozzle of the grill burner:

• remove the screw and then slide out the grill burner “V”

(see Fig. E);

• unscrew the grill burner nozzle using the special socket

spanner for the nozzles (see Fig. F) or better still a 7 mm

socket spanner; replace the nozzle with a nozzle for the new

type of gas (see table 1).

Fig. E Fig. F

Regulating the Primary Air for the Oven Burner

The oven burner do not need to be regulated in terms of

primary air.

Important

On completion of the operation, replace the old rating sticker

with one indicating the new type of gas used. This sticker is

available from our Service Centres.

Note

Should the pressure of the gas used be different (or vary) from

the recommended pressure, it is necessary to fit a suitable

pressure regulator onto the inlet pipe in compliance with current

National Regulations relative to “regulators for channelled gas”.

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit K6T21(X)/EX Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Barbrque & Grills Indesit K6T21(X)/EX